2025 Photo Program

At Labsurface, we recognize the importance of high-quality installation photos to showcase the durability, performance, and aesthetics of our products. That’s why we’re launching a new Photo Program, and we need your participation!

INSTALLERS:
Submit your photos & get free products!

Each approved submission will receive a free kit of Labsurface epoxy or polyaspartic, provided by your distributor.

DISTRIBUTORS:
Boost submissions, earn a pallet of product!

At the end of 3 months, the distributor with the most installer submissions will receive a pallet of their choice of Labsurface epoxy or polyaspartic.

📸 PHOTO TIPS FOR BEST QUALITY

• Use good lighting
  Natural light is best, but if indoors, ensure adequate lighting
• Keep the camera steady
  Use both hands or a tripod to avoid blurriness
• Frame your shot properly
  Take the “before” and “after” shots from the exact same angle
• Clean the camera lens
  A simple wipe can improve image clarity
• Avoid shadows and reflections
  Adjust angles to reduce glare from overhead lighting

LIMIT: One (1)  submission per installer per month.
TIMEFRAME: Three (3) months – starting on April 1^st and ends on July 1^st, 2025.

SUBMISSION REQUIREMENTS:
✔ Two (2) photos per submission – One BEFORE photo and one AFTER photo, taken from the SAME ANGLE.
✔ Clear images – Blurry or low-quality photos will not be accepted as determine by Labsurface (if a photo is rejected, documentation or reasons will be provided).
✔ Low resolution for initial review – A screenshot of your photo qualifies as low resolution. If your project is selected, we will contact you to obtain the high-resolution versions.
✔ High-resolution versions – Must be available to be eligible for the program.
✔ After photo requirement – The final photo must be taken in a clean, finished environment, free of construction or renovation traces, to best showcase the completed installation.
✔ Required information – *Mandatory fields in the form below